Oase IceFree 4 Seasons Notice D'emploi page 7

Install the float
How to proceed:
 G
1. Push the stop plug into the opening of the float from the top.
– Push it into the float as far as possible.
2. Attach the nozzle pipe onto the stop plug protruding from the bottom of the float.
– Do not push in all the way, but leave a gap of at least 0.25 in. (0.5 cm) between the float and the nozzle pipe.
Fitting the pump
How to proceed:
 E
1. Turn the union nut counter-clockwise and remove it.
2. Open the filter housing, remove the pump from the filter housing.
3. Join the supplied hoses using an adapter piece, fit the union nut on the hose, then push the hose as far as possible
onto the pump outlet.
– Shorten the hose if necessary.
4. Reassemble the unit in the reverse order.
– Guide the power cable through the cable duct at the bottom of the filter housing.
Pond ventilator
For summer mode, assemble and set up the unit so that it produces a fountain. Install the respective nozzle according
to the desired water spray pattern.
N O T E
Water loss is possible. Do not set up the unit too close to the edge of the pond.
 Keep a minimum distance of 15.75 in. (40 cm) from the edge.
Adhere to the following conditions for dry installation:
 B
 Use a string to fasten the floater on the pond bank.
 Only operate the unit in bodies of water with a minimum depth of 15.75 in. (40 cm).
 Do not immerse the pump as deeply as you would for winter mode (ideally approx. 15.75 in. (40 cm) deep).
Fitting the nozzle
How to proceed:
 D
1. Insert the nozzle in the nozzle pipe and turn clockwise to tighten.
– "Volcano" nozzle: Align the nose at the bottom of the nozzle with the groove in the nozzle pipe, then screw in
place.
2. Adjusting the fountain height: Turn the nozzle in/out by a few revolutions.
Installing the floater
How to proceed:
 F
1. Push the nozzle pipe into the opening of the float from the top.
– Push it in completely so that the nozzle pipe is flush with the float at the top.
2. Take a hose and place a hose connector onto the end of it. Then attach this hose connector together with the hose
to the bottom of the nozzle pipe.
– Only use one hose. Installing both hoses will negatively impact the flow rate of the pump.
- EN -
7