Voltor TC 24 Manuel D'instructions page 30

Limit the time of continued usage to 10 minutes and
rest between 10 and 20 minutes between working
stints.
Never leave the machine unattended.
Do not allow anybody into the working area. The
working area must have a perimeter of at least 3
metres in circumference with the machine in the
middle.
Do not use accessories with this machine that are not
those recommended by the manufacturer as the use
of non recommended accessories could cause severe
damages to the end user, those people in the vicinity
and to the machine itself.
Usage of the machine:
Start the machine following the instructions as per
points 6.3 and 6.4.
Feed the shredder with material by using the hopper.
If the material to be shredded does not have a
large volume the shredder will suction the material,
will shred it and will expel through the ejection
mouthpiece.
If you shred small material, use the pushing accessory
to move the small material nearer the blades. Never
push this small material with your hands or other parts
of your body.
Pushing accesory
Material
30/95
Insert an adequate amount of material in the hopper.
Do not insert too much material as the machine will
block itself.
Caution: The material inserted in the
hopper can move around and whiplash
as the blades suction the material as
well as small material can be expulsed. Maintain
an adequate security distance and always wear
protective goggles, ear protectors and long gloves.
Check that the shredded material is ejected without
problems. If the shredded material accumulates
around the ejection area, stop the machine and clean
this area.
If you desire a finer shredding performance, you can
shred the material more than once.
Blockage of the shredder:
If too much material or if the material is too resistant,
the blades will not be able to cut and the shredder
will stop.
If when introducing material for shredding, you hear
strange noises, stop the machine immediately.
In these cases, you should:
1. Disconnect the
machine from the mains.
2. Loosen the opening
knob.
3. Open the top section
of the shredder.
4. Clean and remove
excess material from
the hopper, from the
blades and from the
ejection mouthpiece.