Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Separate the water supply line from
the refrigerator
1. Remove two water lines by pressing the each
coupler ( 1 ) and pulling the water lines ( 2 )
away.
CAUTION
Do not cut the water line.
Gently separate it from the coupler.
3. Remove the freezer door
A few things to mention first.
• Make sure that you lift the door straight up so
the hinges are not bent or broken.
• Be careful not to pinch the water tubing and
wire harness on the door.
• Place doors on a protected surface to prevent
scratching or damage.
• Is necessary, have two people disassemble the
doors.
1. With the Freezer door closed, remove the
upper hinge cover ( 1 ) using a screwdriver,
and then disconnect the wires by gently pulling
them apart ( 2 ).
(1)
DA68-02981E-10.indb 12
Be careful not to damage the sensor
harness with the hinge cover.
2. Disconnect the electrical harness.
3. Gently lift the clamp.
(1)
(2)
To prevent damage to the clamp or
injuries, do not lift the clamp forcefully.
4. Pull the clamp to remove.
Remove the ground screw by turning it counter-
clockwise.
5. Open the door by 90 degrees. While holding
the door, remove the hinge.
(2)
English - 12
2018. 7. 4.
1:52
Publicité
Table des Matières
