Using The Fan; Switching The Fan On And Off; Fan Time Lag; Stop Delay Time - Kuppersbusch KMI9850.0 Mode D'emploi

Glass cover
The open cover does not need to
be removed.
Operation

4.19 Using the fan

The fan is located in the middle of the hob with the extractor
facing downwards.
Remove the glass cover before initial operation of the fan.
The cover does not need to be removed from models with an
open cover.
Important:
Do not put the cover onto the induction hob! Risk of bur-
ning!
4.19.1 Switching the fan on and off
1. Turn the fan regulator into the required setting 1, 2, 3 or 4.
The symbol for the fan will light up.
The intensive power setting 4 operates for 10 minutes, after
which the power level is automatically reduced to power
setting 3.
2. To switch off the function turn the regulator to 0.
Hint
In order to ensure that extraction functions well with tall cooking
pots (e.g. pots used for cooking asparagus), you can place a
wooden spoon under the lid of the pot.

4.19.2 Fan time lag

The fan time lag is used after cooker in order to remove cooking
odours. The fi lter is also dried in the fan.
Setting the fan time lag
1. Turn the regulator to the right until it stops.
The fan time lag of 10 minutes will be activated. The symbol
for the fan time lag will light up
2. The fan time lag of 60 minutes is activated by turning the
regulator again.
3. The fan time lag function is deactivated by turning the regu-
lator again.
The fan setting can be freely adjusted or changed when the fan
time lag is switched on.

4.19.3 Stop delay time

The fan motor should continue operating for another 10-20
minutes every time the hob has been used for cooking. When
the fan is switched off after having been in operation for at least
15 minutes, an automatic time lag at a low setting will follow for
around 15 minutes.
This guarantees optimal functioning and the removal of remai-
ning cooking steam.
When using a recirculating air fi lter, please always allow for a
stop delay time of 10 - 60 minutes in order to optimally remove
cooking odours.
When the fan is switched on again, in rare cases the odour mo-
lecules present in the fi lter may be combined with steam so that
they are detected again. These remaining odours will disappear
when the fan continues to operate.
Important
When the convection air mode is in operation, ventilation must
be suffi cient in order for the air humidity to be removed.
GB
.
35