Norcold NX61 Manuel D'installation page 13

4. Change the position of the cabinet hinges:
- Using a straight screwdriver, remove and save the lower (straight) hinge pins [64]
from each both of the lower cabinet hinges (See Art02389).
- Remove the two L-shaped plastic covers [273] and the black plastic cover [305] that
are opposite the cabinet hinges (See Art02390).
- Remove and save the screws from the upper cabinet hinge [66a] of each door.
- Put each of these hinges on the other side of the refrigerator as the lower hinge [66b].
- Attach each of these hinges with screws.
- Remove and save the screws from the lower cabinet hinge [67a] of each door.
- Put each of these hinges on the other side of the refrigerator as the upper hinge
[67b].
- Attach each of these hinges with screws.
- Put the two L-shaped plastic covers and the black plastic cover over the holes
that were used by the hinges.
5. Change the position of the door handles and door hinges:
- Remove and save the hinge bushings [74] from each door hinge (See Art02391.
- Remove the screws and the flat door hinge [274a] from each door (on the top of
the upper door and the bottom of the lower door).
- Turn the flat door hinge over and use the screws to attach it to the opposite side
[274b] of each door (on the top of the upper door and the bottom of the lower
door).
- Remove and save the screws and the shaped door hinge [275] from each door
(on the bottom of the upper door and the top of the lower door).
When you remove each door handle [70] from the door, the latch
NOTICE
and the spring will be loose. Be careful not to lose the latch or the
spring.
- Remove and save the two screws that attach each door handle [70a] to the door.
- Pull each door handle away from the door.
Art02389
67b
273
66b
67b
305
66b
273
Installation Manual 13
64
66a
67a
66a
67a
Art02390