Technical Service; Replacement Parts Information; Troubleshooting Chart - Campbell Hausfeld PL Serie Mode D'emploi

Operation
(Continued)
Release all
pressure from the
system before attempting to
install, service, relocate or perform
any maintenance.
Disconnect the
grease gun from
the air supply before lubricating.
PISTON LUBrICaTION
The piston must be lubricated
periodically . Proper lubrication extends
the life of the tool and creates a better
sealing action for the piston . Under
heavy usage, the piston should be
greased with bearing grease every four
months and for light usage only once a
year . To grease the piston, follow the
outlined procedures .

Troubleshooting Chart

Symptom
Tool will not operate
Tool operates, but grease will
not eject from spout
1 . Disconnect the air grease gun from
the air supply .
2 . Remove the four socket cap screws
on the gun head and remove the
spring(s) and the piston .
3 . Apply a film of bearing grease
around the exterior of the rubber
skirt or the o-rings of the piston and
a thin film of grease on the inside of
the cylinder .
4 . Install the spring(s), piston and the
four socket cap screws .
Possible Cause(s)
1 . No grease in tool
2 . Low air pressure
3 . Air hose leaks
1 . Cold, thick grease
2 . Spring is still compressed
3 . Out of grease
4 . Air pockets in container tube

Technical Service

For information regarding the
operation or repair of this product,
please call 1-800-543-6400 .
replacement Parts
Information
For information regarding where to
order replacement parts, call toll free
1-800-543-6400 . Please provide the
following information:
Address parts correspondence to:
Corrective Action
1 . Lubricate the tool according to the lubrication
instructions in this manual
2 . Adjust the compressor regulator as needed
3 . Tighten and seal hose fittings if leaks are found
1 . Bring tool inside and warm to room temperature
of 70°F - 85°F . Stand the gun in an upright position
to prevent air pockets forming in the middle of
the cartridge
2 . Pull the plunger handle back and release quickly .
Make sure the catch plate is released
3 . Refill container tube
4 . Remove air pockets (See Removing Air Pockets
section)
3
PL Series / TL Series
• Model number
• Stamped code
• Part number and description
Campbell Hausfeld
100 Production Drive
Harrison, Ohio 45030 U .S .A .
www.chpower.com