Edesa L836 Manuel D'installation Et D'utilisation page 89

Why is there still some water
in the dispenser?
Why can't I open the hatch
immediately after the wash
has finished?
Why doesn't the remaining
time shown on the clock
coincide with the real time
left until the selected cycle
finishes?
Other anomalies
safety and troubleshooting
This may be because the dispenser needs cleaning. This
simple operation is described in Maintaining and cleaning
the appliance.
1- Cleaning the detergent dispenser.
Washing machines today are provided with safety systems
for users. One of them is that the washing machine cannot
be opened until it is certain that the drum is quite still. This
is why the hatch cannot be opened for 2 minutes.
This time is for guidance purposes only and may be affected
by the conditions under which the selected programme is
being run, e.g. initial water temperature, size of load or
unbalance caused by the garments during spin drying.
The washing machine can detect other indications. When
this happens a number of other indicators appear on the
display: F05, F06, ..., F10 or the wash, rinse and end pilot
lights will flash, together with one of the other control panel
pilot lights.
Check if the problem is repeated and in this case call the
AUTHORISED SERVICE CENTRE.
89