Installation Instructions - Koala Kare KB110-SSWM Mode D'emploi

KB110-SSWM

Installation Instructions

Step 1.
Remove changing station from the shipping container
and check for any freight damage. Identify the best
location for installing the unit. Hold the unit in place and
open the bed. Make sure you have taken the operating
clearance into consideration.
Step 2.
Determine the best method for mounting based on the
type of wall. You may have left over hardware when you
have finished installation.
Step 3.
The horizontal unit has four mounting holes provided
in the back wall, positioned on a 32" (812.8 mm) stud
center. If possible, locate the wood or metal wall studs
for fastening the unit in the desired location. If the walls
do not have studs on center as outlined, make sure at
least one side of the unit is installed onto the stud. Use
toggles (not supplied) for holes on the opposite side.
Step 4.
Find the stud where you will be attaching the left side of the unit to the wall. Measure up from the floor 44"
(1118 mm), at the center of the stud, and mark the wall. Line up Hole A with the mark on the wall. Mark
remaining holes using a measuring tape to make sure the holes are precisely positioned. Hold unit in place
to verify. Use four ¼" x 3" (6.35 mm x 76.2 mm) panhead wood screws with washers (supplied) when wall
studs are available.
If the wall surface is masonry or tile over studs, use a 7/32" (5.56 mm) masonry drill bit for the pilot hole
until you hit the stud. Change bit to 1/8" (3.18 mm) regular drill bit. Use four ¼" x 3" (6.35 mm x 76.2 mm)
panhead wood screws with washers (supplied).
If the wall has metal studs or an underlying surface of concrete block, you will need to use toggles.
Additionally, if the wall has wooden studs that are not on 16" (406 mm) centers, you will need to use toggles
to secure one side of the unit. The other side should be secured to the stud using the screws provided. You
must allow for space inside the wall for the toggles to turn. This will vary depending on the toggles used.
Step 5.
Position Koala sign (supplied) on the outside of the restroom door. Fill the built-in dispenser with sanitary bed
liners. Replacement parts can be purchased from your local distributor or by calling toll free 888.733.3456
or 303.539.8300 in the U.S.
2