Operating And Safety Notes - Hammerbacher VXMST Serie Manuel D'exploitation

7. Operating and safety notes Series: VXMST
Observe the regulations in section 2 safety notes on page 5, particularly:
•
•
•
Leave the immediate vicinity of the frame if it begins to move spontaneously.
Under no circumstances should you try to operate the frame. Do not use the
frame until it has been successfully, completely and professionally repaired.
•
•
•
Discontinue use of the frame if safety risks occur, e.g. switches stop
functioning as they should.
Warning of a risk of crushing and shearing.
Please leave sufficient space to other objects, tables, walls etc. in the entire
lifting area (at least 30 mm) to avoid collisions.
•
•
Warning of injury or damage:
Mounting screws of fitted components or when lifting the desktop can breaj.
•
•
•
Warning of injury or damage:
•
•
Caution voltage:
•
•
•
Do not leave children with the table frame without supervision. Children
are not able to assess the risks associated with this table frame. They
are in great danger of injuring themselves, perhaps even with fatal
consequences.
Do not exceed the maximum time delay on the frame.
E nsure there is sufficient space to avoid collisions. Even if objects such
as computers, work materials or other have been placed on the work
surface.
Discontinue use of the frame if unusual events happen (e.g. loud noises,
smoke formation etc.).
Only have the frame repaired by an expert.
Do not use the frame until it has been successfully, completely and
professionally repaired.
At least 30mm for constant distances
At least 500mm for obstacles that are out of sight
Remove power cables and electrical devices from the socket.
Only hold the upper arm of the foot frame while transporting the table.
Devices or objects standing on the desk could tip over or fall down
Constant use will damage the motor controls on the operating panel.
Do not exceed the maximum duty cycle according to the information on
the type plate.
A n incorrectly connected power cable can cause a fire or an electric
shock.
Only operate the voltage at the mains voltage shown on the type plate.
Do not allow any moisture or water to touch the controls or the power
cable.
55
VXMST