Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Safety information
Dangers due to electrical energy
•
Do not connect the workstation frame to the mains electricity until the assembly is complete.
•
Check the electrical equipment in the workstation frame regularly to see that it complies with national
•
Do not use any wires with damaged insulation. This will increase the risk of electric shock.
new wiring.
•
Do not position the power feed near any sources of heat.
The persistent heat could damage the wire.
•
Disconnect the workstation frame from the mains electricity if the frame is not in use for an extended
period.
Use of the workstation frame
•
Do not allow children to use the workstation frame unsupervised.
Children may be unaware of the dangers presented by the workstation. They would be in serious danger
•
The workstation frame must only be used in appropriate areas (Assembly instructions).
•
Do not use the workstation frame on an uneven surface.
In such conditions it will not be steady.
•
•
Never exceed the maximum load on the workstation frame (
Assembly instructions).
•
the immediate surroundings of the frame.
•
There is a danger of crushing!
•
computers or computer peripherals.
•
all around the workstation frame.
In an emergency
•
Leave the immediate surroundings of the workstation frame at once if it starts to move spontaneously.
Under no circumstances attempt to operate the workstation frame.
Have the workstation frame repaired by specialists.
Refrain from using the workstation frame until it has been successfully repaired.
•
Have the workstation frame repaired by specialists. Refrain from using the workstation frame until it has
been successfully repaired.
•
Stop using the workstation frame at once if its safety features (e.g. up-down switch) fail to work as they
should.
Cleaning
•
Dust the workstation frame once a week with a dry cloth.
•
Clean the workstation frame with a damp cloth and a weak solution of cleaner once a fortnight.
Noise generated by the workstation frame
•
See assembly instructions.
EN
Safety information
Maintenance and upkeep
•
workstation frame checked by specialized employees on a regular basis.
•
Do not perform any repairs on the workstation frame or other components yourself.
•
Do not alter the construction of the work surface or its frame.
•
•
manufacturer. Use only original replacement parts made by the manufacturer. Have any such work
•
Perform a "reset" at regular intervals - at least once a month - take a look at the assembly
instructions.
Persistent risks
This workstation frame has been built to the state of the art and to recognized safety regulations.
must be used only:
•
•
if it is completely safe so to do.
Read and keep the operating and installation instructions
•
The operating and installation instructions are part of this table Table. It contains important
information about commissioning and handling.
•
inserting the table Table.
•
to the table Table.
•
The operating instructions are based on the standards and rules valid in the European Union. Please
•
Keep the operating and assembly instructions near the table for further use. So that you always have
at hand.
•
An electronic version of this manual (PDF) is available from our customer service.
WARNING:
authority to operate the equipment.
Recycling
•
Taking the workstaon out of acve duty:
Pull the power plug out of the electricity socket.
•
Taking the workstaon apart:
In case of de-assembling please follow the manual backwards or contact customer service.
•
Recycling:
Please split all parts to their type of material. Keep notice of National restrictions!
English
EN
Publicité
Table des Matières
