Connect Drain Hose - Whirlpool NTW4500 Mode D'emploi

Remove straight power cord
3.
and cord restraint
D
A
Firmly grasp power cord (A) and
pull to completely free power
cord, cord restraint (B), and pin (C)
from rear panel. Pull cord restraint strap (D) out of plug.
NOTE:
Remove cotter pin if it did not come free with strap.
4.
Remove restraint from power cord
power cord
To remove restraint from power cord: push power cord in,
press tab, and then pull power cord out.
5.
Remove looped power cord
A
Firmly grasp yellow shipping
strap (A) and pull until both ends
are completely removed from
washer. Pull cord restraint strap (B)
out of plug.
NOTE:
Check that two (2) cotter pins (C) came off with strap.
All manuals and user guides at all-guides.com
C
B
tab
restraint
C
B
6.
Place power cord over console
Gently place power cord over console to allow free access to
back of washer.

CONNeCT DraIN hOse

7.
Remove drain hose from washer
cabinet
Gently pull hose out of back of washer cabinet from top until
end emerges.
IMPORTANT:
Do not force excess drain hose back into rear
of washer.
8.
Connect drain hose form
For a laundry tub or standpipe drain, follow steps 8 and 9.
For a floor drain, do not install drain hose form. You may need
alternate parts with separate directions. See "Tools and Parts"
to determine what you may need.
Feed hose into one end of form. Bend hose and feed through
other side, anchoring form on smooth sections of hose.
5