Abus Secvest FUBE50001 Instructions D'installation Et D'utilisation page 37

Installation and start-up
DIP switch layout
6. Adjust the DIP switch as required.
Factory/defa
Role
ult setting*
1
2
3
4
5
6
7
8
12 EN
STATUS LED
Permanent status LEDs
BACK COMP
Backward compatibility
BATT MODE
Battery operation
INFO TONES
Info and alarm tone
sounds on the control
panel
KEY TONES
Keypad tones
PROX ENB
Chip key reader
KEY LED
Permanent keypad
lighting
NU
Rolling code
OFF
The status of the sub-
areas is only displayed for
a few seconds during
operation*
FUAA50xxx*
All versions of firmware
Works in same way as
FUBE50000 (without
rolling code)
Power supply unit
operation
(incl. batteries)*
No info or alarm tone
sounds on the control
panel*
Keypad tones deactivated*
Chip key reader
deactivated
Keypad lighting during
operation only*
(times out after 15
seconds)
WITHOUT
Rolling code
Compatibility as per DIP-
2
ON
Permanent status LEDs
FU80xx
Works in same way as
FU8110
Battery operation
(without power supply unit)
Suppresses the status
message "Ext. PSU error"
on the alarm control panel
Info and alarm tone
sounds on the control
panel*
Keypad tones activated*
Chip key reader activated*
Permanent keypad lighting
WITH
rolling code*
Compatible with Secvest
FUAA50xxx firmware
>=v2.00.03
DIP-2 without effect