Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7. If adjustment is required, rotate microwave oven downward.
Using 2 or more people, lift microwave oven off of mounting
plate and set aside on a covered surface.
8. Loosen mounting plate screws. Adjust mounting plate and
re-tighten screws.
9. Repeat steps 3 through 6.
10. With the microwave oven centered, and with at least one
person holding it in place, insert bolts through upper cabinet
into microwave oven. Tighten bolts until there is no gap
between upper cabinet and microwave oven.
NOTES:
Some upper cabinets may require bolts longer or shorter
■
than 3" (7.6 cm). Longer or shorter bolts are available at
most hardware stores.
Over-tightening bolts may warp the top of the microwave
■
oven. To avoid warping, wood filler blocks (installer to
provide) may be added. The blocks must be the same
thickness as the space between the upper cabinet bottom
and the microwave oven.
A
NOTE: Avoid damage to the mounting nut, screw the bolts into
the mounting nut holes around 5/8"-13/16" (1.5-2.0 cm) by hand
first, make sure the bolts thread in properly. Then tighten with
tools.
A. Bolt
B. Mounting Nut
A. Bolts
5/8"-13/16"
(1.5-2.0 cm)
A
B
11. Connect vent to damper assembly.
A. Vent
B. Damper assembly (under vent) Compact
Complete Installation
1. Install filters. Refer to the User Instructions for filter
placement.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
2. Plug microwave oven into grounded 3 prong outlet.
3. Reconnect power.
4. Check the operation of microwave oven by placing 1 cup
(250 ml) of water on the turntable and programming a cook
time of 1 minute at 100% power. Test vent fan and exhaust
by operating the vent fan.
5. If the microwave oven does not operate:
Check that a household fuse has not blown, or that a
■
circuit breaker has not tripped. Replace the fuse or reset
the circuit breaker. If the problem continues, call an
electrician.
Check that the power supply cord is plugged into a
■
grounded 3 prong outlet.
See the User Instructions for troubleshooting information.
■
Installation is now complete.
Save Installation Instructions for future use.
A
B
11
Publicité
Table des Matières
