Resetting To The Factory Default Settings; Further Information - Axis M32 Serie Guide D'installation

AXIS M32 Series

Resetting to the Factory Default Settings

This will reset all parameters, including the IP address, to the Factory
Default settings:
1. Disconnect power from the camera.
2. Press and hold the Control button and reconnect power.
3. Keep the Control button pressed until the Power indicator flashes
amber (this may take up to 15 seconds).
4. Release the Control button. When the Power indicator displays
green (which can take up to 1 minute) the process is complete and
the camera has been reset.
5. Re-assign the IP address, using one of the methods described in this
document.
It is also possible to reset parameters to the original factory default
settings via the web interface. For more information, please see the
online help or the user's manual.

Further information

The User Manual is available from the Axis Web site at www.axis.com.
Visit www.axis.com/techsup to check if there is updated firmware
available for AXIS M32 Series To see the currently installed firmware
version, see Setup > About in the camera's web pages.
Warranty
For information about Axis' product warranty and thereto related
information, please see www.axis.com/warranty
Page 13