Self Clean - Samsung WF45H6300A Serie Mode D'emploi

selF cleAn+

Self Clean+ is a self-cleaning cycle that removes mold that may occur inside the washing machine.
1. Press the power button.
2. Press the self clean+ button.
• Once the Self Clean+ button is pressed, the
3. Press the start/pause button.
• When you press the Start/Pause button, Self
• Using Self Clean+, you can clean the drum, tub and diaphragm without using a cleansing
agent.
cauTion
• Never use Self Clean+ when laundry is in the washing machine. It may cause damage to the
laundry or a problem with the washing machine.
• If you want to use a drum cleansing agent, use only 1/10 of the amount of the drum
cleansing agent recommended by the cleansing agent manufacturer. (When using a
powder type cleansing agent , remove the liquid detergent compartment.)
The self clean+ auto indicator function
• If the "self clean+" button is lit after a wash, it indicates
that tub (drum) cleaning is required. In this case, remove
the laundry from the washing machine, turn the power on,
and clean the drum by running Self Clean+.
• If you do not run Self Clean+ after every 40 washes,the
"self clean+" indicator turns off after one hour. However,
the "self clean+" indicator will light again after five
washes. Not running Self Clean+ at this point will not
cause a problem with the washing machine.
• Although the Self Clean+ Auto Indicator appears once a
month or so, the frequency may differ depending on the
number of times the washing machine is used.
WF45H6-03385A-01_EN.indd 31
only function that can be set is Delay End.
Clean+ begins.
English _31
2014-3-1 11:38:08