Operating - EUROM XVT-16 Livret D'instructions

Step 5 Mount the weighted foot with a round disc firmly to the support pipe
using the 'L' screw
Step 6 Place the motor housing (including the display housing) onto the
support pipe attached to the assembled base and secure it with the
screw with the plastic handgrip.
For mounting the fan blade and the protective grill, see assembly XVT-16 from step
1.

Operating

Operating the XVT-16
 Use the fan only when:
 The fan is completed assembled;
 All the connections are tightened firmly;
 All the safety instructions have been observed;
 The fan is positioned on a stable and flat ground.
 Check whether the fan speed is set to
 Set the fan in the correct position.
 Insert the plug into an appropriate socket.
 Use the control button to choose the desired speed (
medium,
 The fan will start operating and the LED lighting will turn on.
 If necessary, press the oscillation (swivel) knob (6): the fan will now swivel in
an angle of 45°. By pulling out this knob, you stop the oscillation (swivel)
function.
 To switch off the fan, set the On/Off button to 0
the operation for longer than a few minutes, then also remove the plug form the
socket.
Operating the XVT-16S
 Use the fan only when:
 The fan is completed assembled;
 All the connections are tightened firmly;
 All the safety instructions have been observed;
 The fan is positioned on a stable and flat ground.
 Set the fan in the correct position.
 Plug the plug in the appropriate socket. The red lamp on the display will come
on.
On the control panel or the remote control make the desired choice.
Attention: The corresponding lamps on the display will come on at all the
functions.
turbo, silent).
.
(off). If you want to disrupt
24
off, low,