Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Drawing and assembling
Drawing of the parts of XVT-16
1.
Fan blade
2.
Motor axle
3.
Lock for the protective grill
4.
Plastic base
5.
Rear protective grill
6.
Oscillation (swivel) knob
7.
Motor housing
8.
Tilt support plate
Assembling the XVT-16
Step 1
Remove the packing material and keep it away from children.
Step 2
Before continuing, check that the plug is not plugged into the socket and
the control button is on '0' (off).
Step 3
Mount the plastic base to the motor housing (including the stand). Pull the
electric cable with the plug through the opening in the plastic base and
affix to the base using the three screws included in the delivery.
Step 4
Pull the electric cable through the holder and the opening in the plastic
base.
Step 5
Tighten the plastic screw cap (that affixes the fan blade) of the fan axle.
Attention: you must turn it clockwise to dismount the screw cap (to loosen
it).
Step 6
Tighten the threaded turnbuckle (that affixes the protective grill) of the
motor housing; turn it counter-clockwise to dismount the guard nut (to
loosen it).
Step 7
Place the rear protective grill against the front side of the motor housing
with the carrier bracket on the protective grill facing upwards. Make sure
that the positioning pins of the motor housing are placed correctly in the
slots of the protective grill.
Step 8
Now tighten the guard nut (that affixes the protective grill) firmly
clockwise onto the screw thread of the motor housing.
9.
Tilt axle
10. Stand
11. Front protective grill
12. Plastic screw cap for affixing
the fan blade
13. Control button
14. LED lighting
22
Publicité
Table des Matières
