Humidity And Humidifier; Save Settings; Auto Mode; Controlling Humidity - Air-O-Swiss U700 Mode D'emploi

14
HUMIDIT Y AND HUMIDIFIER
en

SAVE SETTINGS

The AIROSWISS U700 saves the last-used settings when
it is switched off. However, if the appliance is discon-
nected from the power supply for a few seconds, it will
start in the operating mode.

AUTO MODE

In mode the humidification is controlled automati-
cally and the humidity is set to 50%. As soon as the hu-
midity or the humidifier is manually adjusted, however,
the appliance leaves mode.
To return to mode, tap the
The heater can be switched on or off without the appli-
ance leaving mode.
tive when setting the timer.

CONTROLLING HUMIDITY

The humidity can be set between 30% and 70%. In the
"Co" setting (for "Continuous"), the humidifier runs re-
gardless of the measured humidity. This means it does
not switch off until the tank is empty or the appliance is
switched off.
1. Tap the
starts flashing.
2. While the indicator is flashing, tap the
until the desired humidity is set.
symbol once.
The value is applied after a few seconds. The indicator
stops flashing.
mode also remains ac-
symbol. The current humidity indicator
symbol again,

REGULATE THE OUTPUT

1. Tap the symbol multiple times, until the desired
level appears on the display.
The symbol on the display shows which of the three levels
(low/medium/high) has been selected: