Using Your Steam Mop - Electrolux Precision Steam Guide Du Propriétaire

Using your steam mop

The Electrolux steam mop is designed for use on hard-surface floors such as ceramic, stone, marble, vinyl, linoleum,
and sealed hardwood. Do not use on unsealed wood floors. If uncertain, test in an isolated area such as a closet.
NOTE: Heat and steam may remove the sheen on waxed floors or on some no-wax floors. Check use and care
instructions from flooring manufacturer.
C A U T I O N
Be sure steam mop is turned off and unplugged
I
before removing water tank.
Fill tank with clear water only. Do not use
I
chemicals, soap or detergent.
Never use steam mop without cleaning pad.
I
Always direct steam away from yourself. Never
I
direct steam toward people, animals, or plants.
Sweep or vacuum floor before using steam mop.
I
Press release button and lift off water tank (Fig.1).
I
Remove cap and fill tank with clean tap water. Do
I
not exceed maximum fill line (Fig. 2). In areas with
hard water, use distilled water for better
performance.
Put water tank back in place.
I
Place cleaning pad on floor with Velcro loop strips
I
facing up. Set floor nozzle onto pad (Fig. 3).
Turn knob to adjust steam output for type of floor
I
(Fig. 4). See page 5.
Press down front of clean burst pedal to 'floor
I
mop' position (Fig. 5).
Plug in and turn power switch to 'on.'
I
Hold down floor nozzle and pull handle back to
I
comfortable angle for mopping (Fig. 6).
Do not leave steam mop standing on the
!
floor for any length of time while damp
cleaning pad is still on it. If you notice a whitish
'halo' on the floor surface, it can be removed
with a few drops of vinegar.
2 4
Fig 1
TILE WOOD
Fig 3
VINYL
Fig 5
Fig 2
Fig 4
Fig 6