Juiceman JM8000S Mode D'emploi page 7

To get the most juice from the fruits and vegetables, do not force or rush the food
through the appliance.
4. When the pulp container or juice pitcher is almost full (the pulp container holds
about 3½ cups of pulp and the juice pitcher holds about 4 cups of juice) turn off (0).
Allow the motor to come to a complete stop before emptying either part.
5. Follow the instructions in DISASSEMBLING YOUR JUICE EXTRACTOR to remove the
pulp container, then replace following instructions in ASSEMBLING YOUR JUICE
EXTRACTOR. Be sure to replace the containers before resuming extraction.
Caution: The stainless steel filter cutting teeth are very sharp. Handle the filter
carefully.
6. When juicing is complete, open/closed latch should be switched to close ( ).
7. Turn off and unplug from outlet.
Note: Never place fingers or hand into the feed chute.
USING THE SMALL AND LARGE FOOD PUSHERS
Note: The food pusher has 2 parts; the smaller clear inner section locks into
the larger outer section.
1. To remove the small food pusher, hold the large food pusher with one hand and
twist counterclockwise until the lock of the inner section is disengaged;
lift the small food pusher straight up.
2. Place the large food pusher into the feed chute, matching the indentations on the
food pusher to the projections on the feed chute.
Note: Use the smaller opening for small fruits and vegetables. Use the small food pusher
to help guide the fruits and vegetables through the opening in the large food pusher.
3. When using larger pieces of fruits and vegetables, replace the small food pusher
into the large food pusher and use the assembled piece to help guide the larger
fruits and vegetables through the feed chute. Match the notches to the opening. The
clear center will drop into the slot; turn the top clockwise until the small pusher is
locked in place.
JUICE EXTRACTOR TIPS
• Do not put food into the extractor before turning the appliance on.
• Let the appliance run for at least 10 seconds before placing any food into the feed
chute.
• Do not let the juice or pulp container overfill while using the machine. Turn the
appliance off (0), wait for the motor to stop running and any juice to stop flowing.
Empty the juice and/or pulp container. Be sure they are properly replaced before
resuming operation of the extractor.
• Do not process bananas, avocados or coconut. They have no juice and will clog the
appliance.
• Be sure to remove all pits and large seeds from fruits.
• For maximum nutritional benefits, drink your processed juice right a way.
FOR OPTIMUM JUICING
• Avoid excessive build up of pulp on the underside of the lid.
• Remove rind of melons; because they are so thick, they water down drinks.
• Refrigerate washed ripe fruits and vegetables until ready to use.
7