IKA RCT basic Mode D'emploi page 16

• Beware of hazards due to:
- flammable materials
- combustible media with a low boiling temperature
- glass breakage
- incorrect container size
- overfilling of media
- unsafe condition of container.
• The appliance may heat up when in use.
• The base plate can heat up due to the action of the drive mag-
nets at high motor speeds, even if the heater is not operational.
• Process pathogenic materials only in closed vessels under a suitab-
le extractor hood. Please contact IKA
• Do not operate the appliance in explosive atmospheres, with
hazardous substances or under water.
• Only process media that will not react dangerously to the extra
energy produced through processing. This also applies to any extra
energy produced in other ways, e.g. through light irradiation.
• Please observe the operating instructions for any accessories used.
• Ensure that the external temperature sensor (PT 1000, ETS-D...)
is inserted in the media to a depth of at least 20 mm.
• The PT 1000 external temperature sensor must always be in-
serted in the media when connected.
• Safe operation is only guaranteed with the accessories descri-
bed in the "Accessories" chapter.
• Accessories must be securely attached to the device and cannot
come off by themselves. The center of gravity of the assembly
must lie within the surface on which it is set up.
• Always disconnect the plug before fitting accessories.
• The appliance can only be disconnected from the mains supply
by pulling out the mains plug or the connector plug.
• The socket for the mains cord must be easily accessible.
• The device will automatically restart in mode B following any
interruption to the power supply.
• It may be possible for wear debris from rotating accessory parts
to reach the material being processed.
16
• When using PTFE-coated magnetic bars, the following has to be
For protection of the equipment
• The appliance may only be opened by experts.
• The voltage stated on the type plate must correspond to the
® if you have any questions.
• Do not cover the device, even partially e.g. with metallic plates
• Ensure that the base plate is kept clean.
• Protect the appliance and accessories from bumps and impacts.
• Observe the minimum distances between the devices, between
noted: Chemical reactions of PTFE occur in contact with molten
or solute alkali metals and alkaline earth metals, as well as with
fine powders of metals in groups 2 and 3 of the periodic system
at temperatures above 300 °C - 400 °C. Only elementary fluo-
rine, chlorotrifluoride and alkali metals attack it; halogenated
hydrocarbons have a reversible swelling effect.
(Source: Römpps Chemie-Lexikon and "Ulmann", Volume 19)
mains voltage.
or film. This results in overheating.
the device and the wall and above the assembly (min. 800 mm).
>100 mm >100 mm