Inactivity Of The Ice Maker; Cleaning Of The Ice Maker; What To Do If The Refrigerator Does Not Work; The Appliance Does Not Work - Vitrifrigo IM CL REFILL Serie Manuel D'installation Et Mode D'emploi

8. INACTIVITY OF THE MAKER
After using the machine, to keep it in perfect working order and prevent mould
from forming, proceed as follows. Switch off the ice maker and unplug it from the
mains power. Empty out the ice tray (B). Wait for the frost inside the tray to melt
completely. Dry the inside of the ice maker. Leave the door slightly open to allow
air to circulate so that moisture build up does not form inside the tray. For REFILL
versions, empty the tank (D) (see fig. 1) following the instructions in the section
entitled "CLEANING THE ICE MAKER."
9. CLEANING THE ICE MAKER
Before cleaning the ice maker, make sure that it is not connected to the mains power
supply. If connected, unplug it.
EXTERIOR
Wash the ice maker exterior with lukewarm water, rinse with cold water, and dry with
a soft cloth. Do not use abrasive products.
INTERIOR
Remove the ice tray (B) and proceed to clean using warm water mixed with a little
bicarbonate of soda or vinegar. Rinse carefully and dry thoroughly using a soft cloth.
Never use abrasive products, detergents or soap.
CONDENSER
The condenser I) should be cleaned at least once a year (see Fig. 1), using a vacuum
cleaner or a dry soft brush.
TANK (REFILL version only)
The tank G) should be cleaned at least once every three months (see Fig. 1) and
proceeding as follows (see Fig. 3):
a) completely unscrew the screw (1) on the front panel (G) by turning it
anticlockwise
b) slide the front panel downwards for a few centimetres and remove from the
front (3)
c) remove the tank (D) being careful not to disturb the water hose or the power
cable (see Fig. 3)
d) use a screwdriver and loosen the screws (2) and remove the pump (F) from
its seating.
Clean the pump with water.
Follow these instructions in reverse order to reposition the pump in its seating and
replace the front panel, making sure that the pins on the lower fin enter correctly
into the holes on the base of ice maker.
NOTE: when cleaning the tank, be especially careful of the sharp surfaces
to be found on the condenser (I). The use of standard (PPE) protective gloves to
prevent accidental injuries is strongly recommended.
10. WHAT TO DO IF THE REFRIGERATOR DOES NOT WORK
10.1.THE APPLIANCE DOES NOT WORK
Check that:
− power is being supplied to the machine
− the automatic switch of the mains power system has not been switched off
− the plug is in perfect working order and is correctly inserted into the socket
− the socket is in perfect working order. To check this, plug in an appliance
EN
15