N-Com MCS II Mode D'emploi page 9

Prior to installing the N-Com system, remove any filling foam material found in

the helmet.
Option 1: remove the bottom element in foam material and the filling materials in the
housings of the N-Com earpieces located in the EPS cheek pads.
Option 2: remove the left and right side filling material as well as the filling material
in the housings of the N-Com earpieces located in the EPS cheek pads.
Option 1
N.B.: Keep the filling material in case you wish to use the helmet without the N-Com
system in the future.
Option 2
9