Sony IFB-X600E Mode D'emploi page 3

2 Pull out the connector socket from the projector. Insert the
connector socket (set the uneven side on the right) into the
interface board connector plug. Gather the wires together and
place them in the hook of the interface board.
3 Insert the interface board by aligning it with the projector guides.
Caution
Make sure that the wire is not caught between the opening of the
projector and the board.
Wire
Connector plug
4 Tighten the two interface board screws.
3
Hook
Connector socket
3
Uneven side
2
3