Installing Batteries In The Remote Control; Turning The Tv On And Off; Changing Channels; Adjusting The Volume - Samsung LN-R1550P Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installing Batteries in the Remote Control

1.
Slide the cover out completely.
2.
Install two AAA size batteries.
Make sure to match the "+" and "–" ends of the batteries with the diagram inside the compartment.
3.
Replace the cover.
Remove the batteries and store them in a cool, dry place if you won't be using the remote control for a long time. The remote control
can be used up to about 23 feet from the TV.
(Assuming typical TV usage, the batteries last for about one year.)
If the remote control doesn't work, check the following:
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power outage, or is the power cord unplugged?
5. Is there a special fluorescent light or neon sign nearby?
Operation

Turning the TV On and Off

Changing Channels

Adjusting the Volume

Press the POWER
button on the remote control.
You can also use the POWER
Using the Channel Buttons:
1.
Press the CH
or CH
CH
When you press the
You will see all the channels that the TV has memorized. (The TV must have memorized at least three channels).
You will not see channels that were either erased or not memorized.
Using the Number Buttons:
1.
Press the number buttons to go directly to a channel.
To select channel 108, press "
When you use the number buttons, you can directly select channels that were either erased or not memorized.
To change the channel faster, press the channel buttons, then ENTER
(For channel "4" press "4", then "ENTER
Using the PRE-CH Button to select the Previous Channel:
1.
Press the PRE-CH button. The TV will switch to the last channel viewed.
To quickly switch between two channels that are far apart, tune to one channel, then use the number button to
select the second channel. Then use the PRE-CH button to quickly alternate between them.
1. Press the VOL
or VOL
Using MUTE button:
At any time, you can temporarily cut off the sound using the MUTE button.
1. Press MUTE and the sound cuts off.
2. To turn mute off, press the MUTE button again, or simply press the VOL
button on the lower - right side of the panel of the TV.
button to change channels.
or CH
button, the TV changes channels in sequence.
"
"
"
"
".
")
button to increase or decrease the volume.
English-6
.
or VOL
button.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ln-r2050p

Table des Matières