Operation; Switching On - Switching Off - SPARKY HD PROFESSIONAL K 615CE Notice Originale

4. OFF button
5. Switch trigger
6. Regulator of rotation frequency
7. Indicator for brush wear-out and overload
8. Mode indicator
9. Ventilation slots
10. Ventilation slots
11. Tightening nut
12. Auxiliary handle

Operation

This power tool is supplied from single-phase
alternating current mains only. It is double insu-
lated according to EN 60745-1, IEC 60745 and
can be connected to grounded or not grounded
sockets. This power tool is radio suppressed in
compliance with EMC Directive 2004/108/EC.
This power tool is designed for chiselling in brick-
work, concrete and rocks with high efficiency.
This power tool is equipped with a
mechanism for reducing vibrations, decreasing
them by more than 50%.
PRIOR TO INITIAL OPERATION
▪ Make sure the power supply voltage corre-
sponds to the value indicated on the name
plate with technical data of the tool.
▪ Always check the position of ON/OFF switch.
The power tool must be connected to the
power supply socket only when this switch is
in OFF position. If the plug is connected to
a receptacle while the power switch is in the
ON position, the power tool will start operat-
ing immediately, which could cause a serious
accident.
▪ Make sure that the cord and the plug are in
order. If the replacement of the supply cord is
necessary, this has to be done by the manu-
facturer or his agent in order to avoid a safety
hazard.
WARNING: Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance.
▪ In case the work area is remote from the pow-
er source, use as short as practicable exten-
sion cord with proper cross-section.
▪ Check that the auxiliary handle is properly
mounted and reliably tightened.
6
EN
INSERTING Of SDS-MAx TOOL
Clean and grease the shank of the accessory,
before placing it into the socket!
Keep the locking socket 2 in upper (front) posi-
tion while inserting the tool.
Place the tool into the spindle without effort.
Rotate the tool until the grooves coincide.
After the grooves have coincided, push the tool
down (until the fixing mechanism produces an
audible "click"). Check the proper fixing of the
tool by pulling it strongly outwards.
REMOVING THE SDS-MAx TOOL
Pull the locking clutch entirely back and take the
tool out.
CHANGING THE CHISEL POSITION
- Insert the tool in the socket as it is described
in point "Inserting the SDS-max tool".
- Turn the switch 3 in position "Changing the
chisel position".
- Turn the tool by hand to the desired position.
- Turn the switch 3 in position "hammer", and
then turn the tool slightly by hand left wise and
right wise until it is locked.
Longer operation life of the power tool and
higher efficiency can be achieved only with well-
sharpened tools for demolition and chiselling.

SWITCHING ON - SWITCHING Off

▪ Switching on: Press the switch trigger (5) in
the indicated direction.
▪ Switching off: Press the OFF button in the in-
dicated direction.
WARNING: At low temperature ≤ 0
(32 F) or if the power tool has not been used
о
for a long period (after storage in warehouse
/ shop / house) there might be no impact ac-
tion at start because of the thickened lubri-
cant. In this case, let the power tool run for
1.5 minutes at no load in order to warm up,
thus achieving improved lubrication and pro-
longed life of the power tool.
K 615CE ● K 920CE
C
о