Dri-Eaz F354 Manuel De L'utilisateur page 4

MAINTENANCE
Always turn off the power before performing maintenance
procedures. Unplug the unit before performing any service
procedures.
Monthly Maintenance
INSPECT ELECTRICAL SYSTEM: Inspect the electrical cord
and plug for damage, and repair or replace if needed.
INSPECT EXTRACTION EDGES FOR DAMAGE: Before and
after each use, check the edges of the polymer glide
(Shown, on next page) for burrs or sharp edges that could
catch a yarn or damage carpet fibers. Replace polymer glide if
damaged. Order replacement glides from your local distributor.
If the stainless extractor head is accidentally damaged, sand
or file lightly to smooth.
Check edges of polymer glide for damage.
INSPECT POLYMER GLIDE: Check to make sure that the
holes in the polymer glide are not clogged or damaged with
carpet fiber, pet hair, large pebbles, etc.
KEEP UNIT CLEAN: To clean the Rover HVE, use soap and
water on all parts of the base, including the cover, and the
insides of the extraction head and the hose connection.
WARNING! Do not allow water into the control box or motors
through openings like the access holes for the switches. Wipe
the exterior of the control box to clean.
07-01549B 02-06 Copyright 2007 Dri-Eaz Products, Inc.
Polymer glide
Six-Month Maintenance
INSPECT ELECTRICAL SYSTEM: For maintenance contact
an Authorized Service Center, or the Dri-Eaz Service Depart-
ment at 888-867-3235 or (360) 757-7776.
CHECK DRIVE COMPONENTS: Check for corrosion or
misalignment and inspect the entire drive system.
CAUTION! Watch for pinch points and sharp burrs when han-
dling the sheet metal cover, careless handling could result in
an accident. Call an Authorized Service Center or Dri-Eaz
Service for any questions or assistance.
Periodic Maintenance (Every 1-2 years or after 1200-1500
hours of use, whichever comes first)
REPLACE BRUSHES IN DRIVE MOTORS. Have Authorized
Service Center replace brushes in motors to protect them.
TROUBLESHOOTING
The polymer glide can be easily cleared if it becomes ob-
structed. If the opening of the polymer glide becomes clogged
use a wire to dislodge obstruction.
For all other troubleshooting and maintenance questions,
contact an Authorized Service Center, or the Dri-Eaz Service
Department at 888-867-3235 or (360) 757-7776
SPECIFICATIONS
Model
Use weight
Extraction path width
Height
Width
Depth
Height (folded)
Width (folded)
Depth (folded)
Amp Draw
Speed
RPM
Power
Voltage
Cord length
Operator Weight Limit
Specifications are subject to change without notice.
Some values many be approximate.
FOR PARTS AND SERVICE CALL YOUR LOCAL DISTRIBUTOR,
or the Dri-Eaz Service Department at 888-867-3235 or (360) 757-7776
4
F354
67 lbs (30 kg)
19.75" (50.2 cm)
45.7" (116.1 cm)
22.0" (55.9 cm)
27.6" (70.1 cm)
40.5" (102.9 cm)
22.0" (55.9 cm)
10.7" (27.2 cm)
3.0 amps (1.5 DC)
2 speed switch
20
110 W (0.148 HP each motor)
115 Volts
50 ft. (7.6m)
300 lbs (136 kg)