Dri-Eaz F511 Mode D'emploi

R E A D A N D S A V E T H E S E I N S T R U C T I O N S
WARNING
WARNING! Do not alter or modify your Extraction Tool in
any way. Use only replacement parts authorized by Dri-
Eaz Products, Inc. Modifications or use of unapproved
parts could create a hazard and will void your warranty.
Contact your authorized Dri-Eaz distributor for
assistance.
BEFORE YOU BEGIN
Warranty registration
Visit warranty.drieaz.com to register your purchase.
Registration allows us to better assist you with using,
maintaining or servicing your equipment, as well as to
contact you in case we have important safety information
concerning this product. If you determine service is
required, have your equipment model, serial number and
original proof of purchase available and call your
PARTS IDENTIFICATION
Handle. May be
used right- or left-
handed.
Vacuum break lever.
Squeeze to release
vacuum.
View window. View extraction
progress. Window panel may be
removed for cleaning as needed.
Extraction glide. May be
replaced when damaged or
worn.
07-01854C F511
Owner's Manual
Dri-Eaz Extraction Tool
Model F511
DRI-EAZ PRODUCTS, INC.
15180 Josh Wilson Road, Burlington, WA 98233
Phone: 800-932-3030 Fax: 360-757-7950 www.Dri-Eaz.com
Patents: http://www.LBpatents.com
Vacuum hose
attachment.
distributor for assistance with obtaining a return material
authorization (RMA).
MAINTENANCE
As needed:
1. Wipe unit clean with a mild detergent. Do not use
abrasive cleaners or strong cleaning agents.
2. If view window becomes dirty, remove and wash in
warm, soapy water. Do not use abrasive cleaners. Flush
out interior of wand head with clear water.
3. Inspect vacuum break seal. If seal is torn or worn,
contact your Dri-Eaz distributor for a replacement.
4. Inspect extraction glide for wear or damage. If the
head is deeply scratched or excessively worn, contact
your Dri-Eaz distributor for a replacement.
EXTRACTION TIPS
1. For best results, use the tool with a professional
extractor such as the portable HVE 3000 or a
truckmount extractor. Consumer-type wet/dry vacuums
do not provide adequate vacuum.
2. Move the tool back and forth in long overlapping
strokes. Keep the extraction glide flat to the surface. It is
not necessary to press down on the tool.
3. If the vacuum pressure causes the tool to "grab" the
surface, briefly squeeze the vacuum break to release the
tool, then resume extraction.
SERVICE
For parts and service call your local Dri-Eaz distributor.
Copies of the Extraction Tool manual and related
information are available at www.Dri-Eaz.com. Go to
warranty.Dri-Eaz.com to register your purchase.
SPECIFICATIONS
Model
Weight
Dimensions
Construction
Specifications are subject to change without notice. Some values
may be approximate.
1
Dri-Eaz Extraction Tool F511
8.2 lbs. | 3.7 kg
Tube diameter: 2 in. (o.d.)
Head width: 14 in. | 35.6 cm
Handle height: 42 in. | 106.7 cm
Total length: 52 in. | 132.1 cm
Tube thickness: 0.035 in. | 0.089 cm
Stainless steel tube and vacuum break
assembly; rotomolded handle and extraction
head; plastic extraction guide.
Dri-Eaz Products, Inc.