Dri-Eaz F354 Manuel De L'utilisateur

Owner's Manual – Dri-Eaz Rover
The Rover HVE is a high-performance extractor designed for commercial use
SAFETY INFORMATION
WARNING
ELECTRIC SHOCK HAZARD
WARNING! Unit must be grounded.
Insert 3-prong plug on power cord into
an electrically grounded outlet
Do not use adaptor
Never cut off third prong
WARNING! Keep motor and wiring dry.
Do not operate in more than ½ inch of standing water.
Do not operate in rain or snow. Use indoors only.
Do not use hose or pressure washer to clean electri-
cal compartment. Follow cleaning instructions in
manual.
If electrical components become wet, allow them to
dry before using.
WARNING! Unplug unit before servicing.
WARNING! Wait for electricity to dissipate before opening
control box.
SAFETY INSTRUCTIONS
•
Read and understand manual before operating.
•
Be careful not to run over, catch, or damage the cord.
•
Turn off all controls before unplugging. Unplug when
not in use. Do not unplug cord by pulling on cord,
instead pull on plug only.
•
Look out for obstructions or hazards before backing
up or turning, use extra care when near stairs. Keep
Children Away: Do not allow children to play with or
around the unit. Be sure the unit is inaccessible to
children when not attended.
07-01549B 02-06 Copyright 2007 Dri-Eaz Products, Inc.
High Volume Extraction (HVE)
DRI-EAZ PRODUCTS, INC.
15180 Josh Wilson Road, Burlington, WA USA 98233
Fax: (360) 757-7950 Phone US: (360) 757-7776
in restorative drying, to extract water from flooded carpet and carpet pad.
Read And Save These Instructions
www.dri-eaz.com
(Patent Pending)
INTRODUCTION
The Rover HVE is a high-pressure volume extractor for com-
mercial use in water damage or flood damage restoration. It
maximizes water removal from all kinds of carpet to facilitate
faster drying.
The Rover HVE utilizes a replaceable polymer glide head with
a smooth, self-healing edge that easily glides over the carpet.
The Rover is propelled by two .15 HP electric motors through
operation of the joystick.
•
Separate drive wheels allow the Rover HVE to maneuver
around corners with ease.
•
Replaceable polymer glide moves smoothly over all
carpets
•
The joystick is rated for 10 million cycles.
•
Two-speed switch optimizes extraction effectiveness.
•
Collapsible handle for space-saving storage and ease of
transport.
•
Front loading wheels make it easy to transport the
Rover HVE from the van to the job and back.
•
LED light illuminates the floor in front of the Rover HVE.
•
Extraction is monitored through the clear take-up tube.
PARTS INDENTIFICATION
Hi/lo switch
Calibration
button
On/off
button
Light
Front
transport
wheels
for loading
Replaceable
polymer
glide
Stainless steel
vacuum head
(Shown, below)
Joystick
Molded-in
handlebars
Circuit breaker
Clear take-up tube
Footpad
Rotomolded deck
Tethered locking pin
Urethane
plastic
traction
wheels