Troubleshooting - Pioneer SGY-HR500 Manuel De L'utilisateur

Troubleshooting

If you have problems with your device, check the following items.
EN
If a solution to your problem cannot be found here, contact your dealer.
■ Heart rate information is not displayed on the cyclocomputer. /
I cannot pair the sensor with the cyclocomputer.
Cause
The battery is almost empty.
(+) or (-) side of the battery is
installed in the opposite side.
The battery is not installed correctly. Install the battery again (see page 16).
The transmitter is off the strap.
Sensitivity of the sensor has become
low due to dirt on the snap fasteners
or electrode pad.
Sensitivity of the sensor has become
low due to rust of the snap fasteners.
The electrode pad of the strap is
damaged.
The heart rate signal is not detected
because the electrode pad is not
wet.
■ The strap becomes loose. / The hook etc. has broken.
Cause
18
Solution
Replace the battery with a new one (see page 16).
Install the battery in the proper side (see page 16).
Install the transmitter firmly to the strap (see page 14).
Wipe off dirt from the snap fasteners or electrode pad.
Attach and remove the strap to and from the transmitter
several times. If the problem continues, replace the
strap with a new one.
Replace the strap with a new one.
Wet the electrode pad with water (see page 14).
Solution
- Replace the strap with a new one.