Installing The Remote Control; Filling The Water Tank - Duux Beam mini Manuel D'utilisation

• Do not add aromas or similar substances to the
water tank of the device.
• Do not use in the kitchen.
Please keep away from heat sources and avoid
•
direct sunlight.
This appliance can be used by children aged
•
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. Cleaning and
user maintenance shall not be made by children
without supervision.
Be aware that high humidity levels may
•
encourage the growth of biological organisms in
the environment.
Do not permit the area around the humidifier
•
to become damp or wet. If dampness occurs,
turn the output of the humidifier down. If the
humidifier output volume cannot be turned
down, use the humidifier intermittently. Do not
allow absorbent materials, such as carpeting,
curtains, drapes, or tablecloths, to become
damp.
• Never leave water in the reservoir when the
appliance is not in use.
Empty and clean the humidifier before storage.
•
Clean the humidifier before next use.
6
Placing the filter
1. Remove the device from its packaging. Store the
packing materials for future transportation and
storage.
off and take out the filter
2. Take the lid .
3. Remove the plastic seal from the filter.
4. Take out the transparent cover
.
5. Position the filter in bottom of the water tank
over the valve.
6. Push and turn the filter counter clockwise to fix
in place.
7. Place the transparent cover
and lid back on
top of the watertank
.

Installing the remote control

1. Flip the remote and open the battery cover by
pressing and sliding it backwards.
2. Place the battery in the correct orientation.
TIP: When the buttons are facing down,
the '+'-side of the battery should face up.
3. Slide the battery cover back in place until you
hear an audible 'click'.
NOTE:
• Only use 1x CR2032 battery.
• Safely dispose empty batteries.
• Remove the battery if the remote control is to
be stored unused for a long period of time.

Filling the water tank

WARNING: Only fill with cold or lukewarm water.
Hot or boiling water will damage the device.
1. Unplug the power cord and take off the lid
.
2. Fill the water tank
with water using a watering
can or container .
WARNING: Do not exceed the "MAX" level
on the transparent cover.
and make sure it fits
3. Place back the lid
properly.
4. Plug the device back in the power outlet.
5. You may now turn on the device.
NOTE: Always unplug the power cord when filling the
water tank.
NOTE: When using the device for the first time, the
water may have a slight smell and discoloration. This
is normal and not harmful for your health.
7