Bose DesignMax DM2C-LP Notice D'utilisation page 6

Setup
Assembling the Tile Bridge
Note: If you are installing in a hard ceiling, assemble the tile bridge after inserting the rails and ring through the hole
cutout (see page 7).
1. Align the rails and insert the tabs into the slots.
2. Pull the rails outward to secure them together.
3. Align the rails parallel to each other and press the tile bridge ring down to secure the ring to the rails.
q
Note: Installation in close proximity to cooking surfaces where the loudspeaker may be directly exposed to cooking oils,
such as in commercial cooking environments, may decrease the performance or functionality of the loudspeaker.
Preparing Acoustic Ceiling Tile
Cutting the Ceiling Tile
1. Remove the tile and use the template to trace
a loudspeaker hole onto the tile. To center the
template on the tile, draw an X by connecting
the corners diagonally and center the template
using the crossing point.
2. Cut a hole into the tile.
Installing the Tile Bridge
1. Place the assembled tile bridge across the
ceiling grid. If necessary, adjust the tile bridge
so the rails rest on the ceiling grid.
2. Replace the tile in the ceiling.
6 • English
w
q
e
q
PRO.BOSE.COM
w
w
DesignMax DM2C-LP • Installation Guide