Control Panel And Features - Maytag MVWC565FW Guide D'utilisation Et D'entretien

CONTROL PANEL AND FEATURES

1
SOIL LEVEL
1
Select the setting most suitable for your load. For heavily soiled
and sturdy fabrics, select Heavy Soil Level for more wash time.
For lightly soiled and delicate fabrics, select Light Soil Level
for less wash time. A lighter soil-level setting will help reduce
tangling and wrinkling.
WASH TEMP
2
Wash Temp senses and maintains uniform water temperatures
by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric and soils
being washed. For best results and following the garment-label
instructions, use the warmest wash water safe for your fabric.
• On some models and cycles, warm and hot water may be
cooler than your previous washer.
• Even in a cold- and cool-water wash, some warm water may
be added to the washer to maintain a minimum temperature.
All rinses are cold.
3
WASH CYCLE KNOB
Use the Wash Cycle knob to select cycles on your washer. See
"Cycle Guide" for detailed descriptions of cycles.
4
RINSE OPTIONS
The following options may be added to most cycles. See "Cycle
Guide" for additional details.
1 RINSE
This option is used to limit a cycle to one rinse.
2 RINSES
This option can be used to automatically add a second rinse
to most cycles.
1 RINSE WITH FABRIC SOFTENER
This option must be selected if using fabric softener during a
cycle. It ensures that fabric softener is added at the correct
time in the rinse for even distribution.
TWO RINSES WITH FABRIC SOFTENER
This option turns on both the Fabric Softener and the
2 Rinses option.
4
2
Not all features and options are available on all models.
Appearance may vary.
3
7 6
WATER LEVEL
5
Set the Water Level knob to the Auto Sensing setting and the
washer will automatically sense the appropriate water level for
the load size and type.
Set the Water Level knob to the Deep Water Wash setting and
the washer will fill to the maximum water level.
NOTE: Expect longer cycles times due to extended fill times
when using the Deep Water Wash option.
6 START/PAUSE BUTTON
Press to start the selected cycle. Press again to pause the
cycle and unlock the lid. Press and hold 3 sec. to cancel a cycle.
NOTE: If the washer is spinning, it may take several minutes
to unlock the lid.
Press and hold 3 sec to cancel a cycle and drain the water from
the washer.
PROGRESS LIGHTS
7
The Progress Lights show the progress of a cycle. At each
stage of the process, you may notice sounds or pauses that are
different from your previous washer.
SENSING
When the Start/Pause button is pressed, and the Water
Level knob is set to Auto Sensing, the washer will fill and
begin sensing to determine load size and balance.
Once sensing is complete, the washer will fill to the
appropriate level for the detected load size and then
begin the wash phase of the cycle.
NOTE: Sensing and wash phases will be paused by opening
the unlocked lid. Close the lid to resume the cycle. If the lid
is left open for more than 10 minutes, the washer will cancel
the cycle and pump out the water. The lid will lock after the
wash phase to begin the initial spinout and remain locked for
the remainder of the cycle.
4 5