Loading Media - Brady BSP45 Mode D'emploi

6

Loading Media

Loading Media
1. Ensure that the E-stop (safety switch) is
released. If not, twist the red E-stop knob
clockwise and pull out. Then, gently lift the
rear door. Opening this door releases the
safety lock, which automatically evacuates
the system air and removes electrical power.
1
3. Lift and flip up the door covering the rear
tractor pin feed.
3
BSP45 User's Manual
2. Press the extended latch on the lower front
of the die module to release it. The die
module automatically opens to a set
position.
2
4. Load the media with the notch on the edge
of the cardstock (marked with the red circle)
facing towards the front of the unit. The blue
lines on the back of the cardstock should
face down. A minimum cardstock length of
6 inches is required
Note: For proper operation, the
minimum length of media that can be
loaded is 6 inches.
4
ENGLISH
2/25/16