Changing Dies/Sleeve Size - Brady BSP45 Mode D'emploi

4

Changing Dies/Sleeve Size

Changing Dies/Sleeve Size
In order to apply the desired sleeve, you must install the correct mandrel and dies that correspond to
the chosen sleeve diameter. For instance, for 0.125-inch diameter sleeves, the associated 0.125-
inch mandrel and 0.125-inch dies must be installed. Both the mandrel and the dies are stamped with
the sleeve diameter.
1. Press the Function button on the bezel.
Both dies display.
1
3. Insert the desired die into the slot and
gently push down until it clicks. The release
tab will flip back into place.
3
The dies return back under the housing. The machine is now ready for operation.
See Changing Mandrel
BSP45 User's Manual
(page 5) to complete the material changeover process.
2. Push the silver die release tab (circled)
toward the back of the machine. While
holding the release tab with one hand, with
the other hand grasp the die and pull
straight up and out.
2
4. On the unit's front panel, press the sleeve
size selection button corresponding to the
size of the inserted dies.
4
ENGLISH
2/25/16