Rosenbauer HEROS-xtreme Mode D'emploi page 31

Before the slider is employed, the helmet strap should be set as "minimum" in
order to make access easier.
WARNING: When adjusting the sliders, attention should be paid to the
audible locking of the slider following setting, in order that the safety
function of the interior harness is guaranteed.
4.3 Basic setting of the headband
Apart from the adjustment of the wearing
height of the head net, there are a number
of fitting possibilities using the headband.
The height of the headband can be set in
three positions.
The easiest way is to set the hat size
setting to the minimum size.
Size regulator to be turned on to „minimum"
Subsequently, the shaft of the size adjustment
mechanism must be removed from the setting
screw.
Then the four straps linking the headband
with the helmet strap must be loosened.
The complete headband can then be
removed from the helmet by turning it 90°.
The pin in the forehead area can then be
positioned to the appropriate height
(three possible settings). Subsequently,
the headband can be reinserted using
the aforementioned process in reverse
(turn 90°, secure the linking straps,
press the shaft into the setting screw).
WARNING: When adjusting the pin in
the forehead area, ensure that it sits
properly before turning it 90°, as this
will reliably prevent damage.
There is also the facility to establish a
basic setting for very small heads.
User Guide HEROS-xtreme - Rosenbauer
Size regulator to be turned on to
„minimum"
EN
31 31