Rosenbauer HEROS-xtreme Mode D'emploi page 30

Rosenbauer - User Guide HEROS-xtreme
recommend that all-round neck protection and a flame protection hood be used.
4. Instructions for use
4.1 Helmet size adjustment:
A basic helmet setting can be established as
a result of the unique possibility provided for
adjusting the headband to the respective head
size from the outside.
The setting screw on the outside of the helmet can be used to adjust the size
from 51 to 65; if the hat size is smaller, the basic width of the headband can
also be adjusted (see 4.3). Open the helmet harness, put the helmet on and
tighten the harness until the helmet sits firmly,
without a feeling of excessive pressure.
Naturally, the helmet can be
further adjusted during operations to
the prevailing conditions, taking into
account all safety regulations.
4.2 Adjustment of the wearing height
Setting takes place using two sliders with ten locking points on the headband,
which are located on the left and right at the rear of the interior harness.
Setting should take place in such a way that the eyes are positioned in line with
the middle of the visor.
The correct setting, roughly with eye level situated in thge middle of the visor.
The correct setting, roughly with eye level
situated in thge middle of the visor.
The sliders are also used to regulate the
distance between the visor and the nose.
If the slider is moved inwards towards the
helmet shell, this creates a bigger gap
between the nose and the visor, while the
reverse procedure reduces this distance.
30 30
Putting on
the helmet
WARNING! Once the screw locks, do
not employ force to turn it further.
1/2
1/2