Dolby Digital Setup; Video Setup; Preference Page - THOMSON HT450 Mode D'emploi

USE
3D function
It is recommended to enable the Pro Logic II function when
you play a DVD, and to disable it again when playing an
audio CD, VDC or a data disk.
• Pro Logic II
Start/Stop/Auto
Mode: Pro Logic mode selection: Music, Films, Pro
Logic or Auto.
Panoramic: Enables reproduction of the same sound
parameters on the rear and front speakers.
Dimension: Adjusts front/rear balance. There are 7
setting modes.
Center Width: Allows distribution of left and right
speakers sound through the center channel, for a
better merged sound output. Setting is achieved
gradually on 8 positions.
Note: Panoramic, Dimension and Center Width are available
in music mode only. These options enable customization of
Pro Logic II.
• Reverb mode: adjusts the ambience of a sound effect.
There are several modes available: Concert, Hall, Room,
Bathroom, Cave, Stadium or Church.

DOLBY DIGITAL SETUP

Dual Mono: Stereo (stereo signal), L-Mono (left channel
signal), R-Mono (right channel signal), Mix-Mono (mixed
signal).
Dynamic (linear compression rate): OFF, 1/8, 1/4, 3/8, 1/2,
5/8, 3/4, 7/8 and FULL.
EN 20
HOME CINEMA
HT450

VIDEO SETUP

Component:
• Component can be set to S-Video, YUV or RGB.
Resolution:
HDMI output mode selection: 480i, 576i, 720p50, 720p60,
1080I50, 1080I60, 1080p (50Hz), 1080p (60Hz).
Quality:
• Sharpness.
• Brightness.
• Contrast.
• Gamma.
• Hue.
• Saturation.
• Luma delay.
HDMI Setup:
• HDMI output : On/Off modes.
• Audio Source : AUTO/PCM.

PREFERENCE PAGE

Video Standard: PAL, Multi, NTSC.
Audio
Selection of DVD playback audio language (8 languages
available).
Subtitles
Selection of DVD playback subtitle language (7 languages
available).