Remington MB350L Mode D'emploi page 6

ENGLISH
• Turn the wheel clockwise for shorter length, anti-clockwise for longer length.
• The wheel will click into place as it reaches each setting and the setting number will
appear on the length position indicator.
Setting Description
1 Stubble or cropped look
2
3 Short
4
5 Medium
6
7
8
9 Long
TO THIN AND TAPER THE BEARD/MOUSTACHE
1. Fit the adjustable comb.
2. Use the zoom wheel to set the comb to the desired length setting.
3. The setting will appear on the length position indicator. If you are trimming for the first
time start with the maximum trimming length setting.
4. Turn the unit on.
5. Place the flat top of the trimmer comb against the skin.
6. Slowly slide through the hair. Repeat from different directions as necessary.
7. If hair builds up in the trimmer comb during the trimming process, switch the unit off,
pull the comb and brush the hair off.
Note: Use the beard trimmer without the adjustable comb for trimming hair close to the
skin. This will trim hair to 1mm, holding the blades perpendicular to the skin will trim hair to
0.4mm.
TRIMMING THE NAPE OF YOUR NECK
Note: you will need a hand mirror for this operation if performing it alone.
1. Remove the adjustable comb.
2. Use your fingers to lift the hair at the base of your head up off the neck. Your index
finger should be covering the roots of the hairs you are lifting to prevent accidental
removal by the beard trimmer.
3. Using your other hand, hold the trimmer to the base of your neck with the cutting unit
facing up and move the trimmer up the length of the neck until it touches your finger
covering the hair roots at the base of your head.
6
Hair length
mm inch
1.5 0.06
2.5 0.1
4 0.16
5.5 0.22
7 0.28
9 0.35
11 0.43
14 0.55
18 0.71