Remington MB350L Mode D'emploi page 5

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 21
PARTS
1. On/Off switch
2. Zoom wheel
3. Length position indicator
4. Indicator light
5. Charging connector
6. Trimmer assembly
CHARGING YOUR APPLIANCE
Before using your trimmer for the first time, charge for 4 hours.
1. Ensure the product is switched off.
2. Connect the charging adaptor to the product and then to the mains.
3. The charging indicator will illuminate.
Charge Level
While charging
Fully Charged
Low Charge
Your trimmer cannot be overcharged. However, if it is not going to be used for an
extended period of time (2-3 months), unplug it from the mains and store.
To preserve the life of your batteries, let them run out every 6 months then recharge for
4 hours.
On a full charge, your beard trimmer will run for up to 60 minutes of cordless usage.
CORDED
Connect the appliance to the mains and turn on.
We recommend you let the product charge for a few minutes before using corded.
CAUTION: Extended mains only use will result in the reduction of the battery life.
INSTRUCTIONS FOR USE
FITTING THE ADJUSTABLE COMB
Hold the trimmer in one hand with your thumb firmly on the zoom wheel to
keep it from turning. Ensure the length position indicator is at 1.
Slide the comb down the grooves until it clicks into place.
The comb can only be attached one way.
ADJUSTING THE TRIM LENGTH
The trimmer comb can be adjusted to give you 9 different trim lengths simply by
turning the wheel to the desired setting.
7. Adjustable comb
8. Detail trimmer
9. Adaptor (not shown)
10. Cleaning brush (not shown)
11. EDGEStyler (not shown)
Indicator light
Green LED will flash
Green LED will come on
Red LED will come on
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
BG
AE
5

Publicité

Table des Matières
loading

Table des Matières