Remote Controller - Mitsubishi Electric Mr. Slim PLA-RP BA Série Manuel D'installation

6. Electrical work
ON/OFF
MODE
CHECK
TEST RUN
SET
Fig. 6-
ON/OFF
MODE
CHECK
TEST RUN
Fig. 6-3
ON/OFF
MODE
CHECK
TEST RUN
SET
Fig. 6-4
MODEL SELECT
TEMP
FAN AUTO STOP
VANE AUTO START
LOUVER h
min
RESET CLOCK
MODEL SELECT
TEMP
FAN AUTO STOP
VANE AUTO START
LOUVER h
min
SET RESET CLOCK
MODEL SELECT
TEMP
FAN AUTO STOP
VANE AUTO START
LOUVER h
min
RESET CLOCK

6.. Remote controller

6..1. For wired remote controller
1)  remote controllers setting
If 2 remote controllers are connected, set one to "Main" and the other to "Sub". For
setting procedures, refer to "Function selection of remote controller" in the opera-
tion manual for the indoor unit.
6... For wireless remote controller
1) Setting (Fig. 6-)
1 Insert batteries.
2 Press the SET button with something sharp at the end.
blinks and Model No. is lighted.
MODEL SELECT
3 Press the temp buttons to set the Model No.
If you mistook the operation, press the ON/OFF
from procedure 2.
4 Press the SET button with something sharp at the end.
and Model No. are lighted for 3 seconds, then turned off.
MODEL SELECT
Indoor Outdoor
PUH, PUHZ, SUZ
PLA
PU
) Automatic fan speed setting (Fig. 6-3)
It is necessary to set for wireless remote controller only when automatic fan
speed is not set at initial setting.
It is not necessary to set for wired remote controller with automatic fan speed at
initial setting.
1. Press the SET button with something sharp at the end.
Operate when display of remote controller is off.
blinks and Model No. is lighted A.
MODEL SELECT
2. Press the AUTO STOP button.
blinks and setting No. is lighted B.
(Setting No.01: without automatic fan speed )
3. Press the temp. buttons to set the setting No.02.
(Setting No.02:with automatic fan speed )
If you mistook the operation, press the ON/OFF
from procedure 2.
4. Press the SET button with something sharp at the end.
and Model No. are lighted for 3 seconds, then turned off.
MODEL SELECT
3) Assigning a remote controller to each unit (Fig. 6-4)
Each unit can be operated only by the assigned remote controller.
Make sure each pair of an indoor unit PC board and a remote controller is assigned
to the same pair No.
4) Wireless remote controller pair number setting operation
1 Press the SET button with something sharp at the end.
Start this operation from the status of remote controller display turned off.
blinks and Model No. is lighted.
MODEL SELECT
min
2 Press the button twice continuously. Pair No. "0" blinks.
3 Press the temp buttons to set the pair number you want to set.
If you mistook the operation, press the ON/OFF
from procedure 2.
4 Press the SET button with something sharp at the end.
Set pair number is lighted for 3 seconds then turned off.
A Pair No. of wireless remote controller
0
1
2
3-9
button and operate again
Model No.
A
001
033
button and operate again
button and operate again
Indoor PC board
Initial setting
Cut J41
Cut J42
Cut J41, J42