Denon DHT-T110 Manuel De L'utilisateur page 3

FCC Information (For US customers)
・Product Name: TV Speaker Base
・Model Number: DHT-T110
・This product FCC ID: 2AAGJDHTT110
This equipment complies with Part 15 of the FCC Rules.
Operation is subject to the two following conditions:
(1) this product may not cause harmful interference, and
(2) this product must accept any interference received,
including interference that may cause undesired operation.
Denon Electronics (USA), LLC
(a D&M Holdings Company)
100 Corporate Drive
Mahwah, NJ 07430-2041
Tel. (201) 762-6665
2. IMPORTANT NOTICE: DO NOT MODIFY THIS PRODUCT
This product, when installed as indicated in the instructions
contained in this manual, meets FCC requirements.
Modification not expressly approved by D&M Holdings
may void your authority, granted by the FCC, to use the product.
3. NOTE
This product has been tested and found to comply with the limits
for a class B digital device, pursuant to Part 15 of the FCC Rules.
The limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This product generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment OFF and ON, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio or television technician
for help.
IC Information (For Canadian customers)
1. PRODUCT
This product IC: 11154A-DHTT110
CAN ICES-3 (B) / NMB-3 (B)
2. CAUTION
To reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that permitted for successful
communication.
Trademark Information
•
Denon is registered trademark of D&M Holdings Inc.
•
Manufactured under license from Dolby Laboratories.
Dolby and the double-D symbol are trademarks of Dolby Laboratories.
•
The Bluetooth® word mark and logos are registered trademarks owned
by Bluetooth SIG, Inc. and any use of such marks by D&M Holdings
is under license. Other trademarks and trade names are those of their
respective owners.
•
©2013 CSR plc and its group companies.
The aptX® mark and the aptX logo are trade marks of CSR plc or one of its
group companies and may be registered in one or more jurisdictions.
DHT-T110E3_140805.indd 3
IC Information (For Canadian customers)
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may
cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may
only operate using an antenna of a type and maximum
(or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more
than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le
présent émetteur radio peut fonctionner avec une antenne
d'un type et d'un gain maximal (ou inférieur) approuvé pour
l'émetteur par Industrie Canada. Dans le but de réduire les
risques de brouillage radioélectrique à l'intention des autres
utilisateurs, il faut choisir le type d'antenne et son gain de
sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.)
ne dépasse pas l'intensité nécessaire à l'établissement d'une
communication satisfaisante.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
Informations sur IC (pour les clients canadiens)
1. APPAREIL
Cet appareil IC: 11154A-DHTT110
CAN ICES-3 (B) / NMB-3 (B)
2. ATTENTION
Afin de réduire le risque d'interférence aux autres utilisateurs, il
faut choisir le type d'antenne et son gain de façon à ce que la
puissance isotrope rayonnée équivalente (p.i.r.e.) ne soit pas
supérieure au niveau requis pour l'obtention d'une communication
satisfaisante.
Rating label
Location: Bottom
3
2014/08/05 10:41:18