Victron energy BlueSolar PWM 12V/30A Manuel page 6

Change Settings Main
display. press on the
MENU key for
several seconds until
the numbers flash, you
are in:
Battery type Battery
voltage
b01 LEAD-ACID 12.0V [24V]
[AGM] 48V
b02 LEAD-ACID 12.0V [24V]
[Gel] 48V
b03 LEAD-ACID 12.0V [24V]
48V
[Wet]
b04* 12V 12.8V
LiFePO4
b05* 24V 25.6V
LiFePO4
*The controllers do not have a remote on/off input. Therefore use LiFePO4 batteries with integrated BMS
only (such as the Victron SuperPack batteries)
NA for 48V
press on the MENU
key again and you are
in:
press on the MENU
key again and you are
in:
4
Main display. It shows battery voltage, battery capacity,
charging and discharging status.
Press MENU to enter next display.
Absorbti Float Low voltage
on voltage disconnect
voltage factory
setting
14.4V 13.7V 11.2V [22.4V]
[28.8V] [27.4V] 44.8V
57.6V 54.8V
14.2V 13.7V 11.2V [22.4V]
[28.4V] [27.4V] 44.8V
56.8V 54.8V
14.6V 13.7V 11.2V [22.4V]
44.8V
[29.2V] [27.4V]
58.4V 54.8V
14.2V 13.35V 11.2V
28.4V 26.7V 22.4V
Solar Voltage display. It shows Solar Panel voltage,
battery capacity status.
Press MENU to enter next display.
Battery type setting.
See table below.
The factory setting is b01
Low voltage Low voltage
disconnect reconnect
range factory setting
10.5V-12.0V 12.6V [25.2V]
in steps of 50.4V
0.1V
10.5V-12.0V 12.6V [25.2V]
in steps of 50.4V
0.1V
10.5V-12.0V 12.6V [25.2V]
50.4V
in steps of
0.1V
10.5V-12.0V 12.6V
in steps of
0.1V
21.0V-24.0V 25.2V
in steps of
0.1V
Low voltage disconnect
The factory setting is 11.2V
[22.4V] 44.8V
Low voltage reconnect
The factory setting is 12.6V
[25.2V] 50.4V
Low voltage
reconnect range
12.0V-13.5V in
steps of 0.1V
12.0V-13.5V in
steps of 0.1V
12.0V-13.5V in
steps of 0.1V
12.0V-13.5V in
steps of 0.1V
24.0V-27.0V in
steps of 0.1V