2.2.
Welding the cables the generator
This section applies only for HERMES and HEMERA strobes
Limatech SAS
31 Chemin de la Crabe
31300 Toulouse
Last Update: 15/09/2021
Step 1: Strip the threads over about 0.2
in.
Step 2: Insert the 2 threads inside the
welding sleeve and make sure they are
overlapping one another.
Step 3: Heat up the sleeve at it center
where the tin is located and wait for it
to melt.
FTECH-2021-000003
V4
Page 12 / 34