Kärcher IVC 60/24-2 Tact2 M Manuel D'utilisation page 12

WARNING
Crush hazard. Never hold your hands be-
tween the dirt container and the intermediate
ring or put them near the lifting mechanism
while locking. Lock the container by pressing
the sliding bow with both hands.
 Plug in the pressure balancing.
Wet vacuum cleaning
Caution: Constantly monitor the fill level in the dirt
receptacle when vacuuming high volumes of liquid,
as the receptacle can be filled within a matter of sec-
onds and could overflow.
DANGER
No dusts hazardous to health should be sucked in dur-
ing wet vacuuming.
– To suck wet dirt, always remove the disposal bag.
General
CAUTION
Please observe the local provisions regarding the
wastewater treatment.
– If wet dirt is vacuumed with the crevice nozzle or if
high volumes of liquid are sucked up from a con-
tainer, it is recommended to deactivate the "Filter
Dedusting" function.
– After the wet vacuuming: Clean the flat-fold filter.
Clean the container with a damp rag and dry it.
Removing the dust disposal bag
 Lock parking brakes.
Illustration
 Remove the pressure balancing at the upper end.
 Pull the locks of the placement mechanics up.
 Pull the push handle upward. The container is un-
locked and lowered.
Illustration
 Pull the container out by the handle.
Illustration
 Put the disposal bag over.
 Tightly seal the disposal bag with closure strips un-
derneath the opening.
 Remove disposal bag.
 Dispose of the disposal bag according to the local
provisions.
 Reinsert the container and lock it with the push handle.
WARNING
Crush hazard. Never hold your hands be-
tween the dirt container and the intermediate
ring or put them near the lifting mechanism
while locking. Lock the container by pressing
the sliding bow with both hands.
 Plug in the pressure balancing.
Rotating knob
–
–
–
–
–
12
Appliance ON
Filter dedusting OFF
Appliance OFF
Appliance ON
Filter dedusting ON
Turning on the Appliance
 Plug in the mains plug.
 Switch on the appliance at the rotating knob.
Adjust the suction hose cross section
Note: The different suction hose sections are required
to allow an adjustment to the connection sections of the
accessory parts.
 Set the minimum volume flow for the suction hose
cross section at the rotary switch.
The scale displays the suction hose cross section.
Automatic filter cleaning
The appliance has an innovative dual filter cleaning sys-
tem that is particularly effective with fine dust. The flat
pleated filter is automatically cleaned every 7.5 seconds
through an air jet (pulsating sound).
Turn off the appliance
 Switch off the appliance at the rotating knob.
 Pull out the mains plug.
After each operation
Empty container (wet vacuum cleaning)
 Lock parking brakes.
Illustration
 Remove the pressure balancing at the upper end.
 Pull the locks of the placement mechanics up.
 Pull the push handle upward. The container is un-
locked and lowered.
Illustration
 Pull the container out by the handle.
 Empty the container.
 Reinsert the container and lock it with the push
handle.
WARNING
Crush hazard. Never hold your hands be-
tween the dirt container and the intermediate
ring or put them near the lifting mechanism
while locking. Lock the container by pressing
the sliding bow with both hands.
 Plug in the pressure balancing.
Change dust bag (dry vacuum cleaning)
 If necessary, replace the dust bag as described un-
der point "Care and maintenance".
Cleaning the device
 Vacuum and wipe the appliance inside and outside
with a damp cloth.
Storing the Appliance
 Wrap the mains cord around the cable holder.
 Wind the suction hose around the sliding bow.
 Insert the floor nozzle and the suction pipe into their
respective holder.
 Place the appliance in a dry room and secure it
from unauthorized use.
– 3
EN