Zeegma Handig Manuel De L'utilisateur page 5

How to install:
1. Set the water tank lock button (6) in the position allowing unlocking the tank.
Remove the tank, pull downwards. Pour a suitable amount of water in, and then
put the tank back on. Switch the lock key to lock the water tank again .
2. Supply power to the device and press ON/OFF key (8), the light should go on.
The steamer will start heating up. After forty seconds, the device will be ready
for operation.
3. Pressing the power button again will control the steam released.
Three levels of adjustment are possible:
MAX (red) approx. 30 g
MEDIUM (blue) approx. 25 g
MIN (green), approx. 20 g
4. When the steamer heats up, do not press the steam activator (3). You can do
so after the heating up has finished. If the process has been finished, press this
button – the steam will be released. If you take your finger away, steam will not
be released. You can cause the steam to be generated continuously – to do so,
press the key and slide it downwards (4).
5. You can connect the product to the water bottle instead of water tank.
How to iron:
The steamer is designed to iron and freshen up creased clothes, drapes, as well as
decorative items. It is safe for most fabrics.
Note!
Before you start ironing, check labels and suggestions on cleaning and maintenance. Make
sure the manufacturer of the fabric you wish to iron does not prohibit steam ironing.
Note!
The dish is suitable for use with clothes hung vertically or arranged horizontally. When
ironing horizontally, make sure that the end of the hose in the tank is immersed in
water
1. Check if the fabric used to manufacture the clothing is permeable so that steam
does not accumulate on it and does not dampen it.
2. Check pockets in the clothes you wish to iron and make sure there are no items
left.
EN