Chap 7 Settings; Chap 8 Scrapping - Elettrobar FAST 570.035 Manuel D'emploi

UK
The following settings should only be configured by a qualified technician.
The parameters listed below can be set during installation or afterwards, accessing the settings menu
as follows:

With the machine on and the door open.

Hold pressed START (4) for 5 seconds; the boiler temperature will appear on the DISPLAY (7).

It will then be possible to change the value indicated by repeatedly pressing START (4).

Once you have selected the desired value, hold pressed START (4) to confirm and move to the
next parameter.

The parameters will be displayed in the order indicated in the table below.
Tank
Temperature
Boiler
Temperature
Dosage
Detergent
Dosage
Rinse Aid
The list of parameters may vary according to the type of machine.
Our machines do not contain materials requiring special handling.
(Applicable in the EU and countries with sorted waste disposal)
The mark applied to the product or its documentation indicates that it must not be
scrapped
waste when it reaches the
end of its service life. To
prevent damage to the
environment or health risks
due to improper scrapping, keep this
product separate from other waste and
recycle it so as to promote sustainable
use of materials.
Corporate users are requested to contact
their supplier and check the terms and
conditions of the purchase contract.
The product may not be scrapped together
with other commercial waste.
Page 12 of 14
INSTRUCTION MANUAL FOR DISHWASHERS
Tub temperature setting.
The change will only be applied to the programme at the moment
selected.
Boiler temperature setting.
The change will only be applied to the programme at the moment
selected.
Detergent dosing time.
Rinse aid dosing time.
with domestic

Chap 8 SCRAPPING

Symbols Object
Sheet
Cardboard packaging
Wooden pallet
Plastic parts
Motors
W
E
Electric parts
E
Electronic parts
E
Rubber parts

Chap 7 SETTINGS

Material
%
Steel
PAP
80
ISPM15
PP, PP+FV
Assemblies 20
EPDM