Chap 4 Using The Machine; Key And Symbols; Switching The Dishwasher On; Filling The Rack - Elettrobar FAST 570.035 Manuel D'emploi

Referring to Fig.1:
1 ON/OFF BUTTON
2 STATUS SELECTION BUTTON
3 PROGRAMME SELECTION BUTTON
4 START BUTTON
The arrangement of buttons and leds may vary according to the machine type

Turn on the main power switch and open the external water tap.

The two lines on the DISPLAY (7) show that the mains power is on.

Check the presence of the overflow.

Press ON/OFF (1).

The water filling and heating stage starts automatically; LEDs (5) and (6) flash alternately and the
boiler temperature is shown on the DISPLAY (7).

When the LEDs (5) and (6) stop flashing and stay steadily illuminated, this indicates that the
optimum conditions to start washing have been reached.
Referring to Fig.3, to ensure the correct operation of the dishwasher follow the rules described below:

Use a suitable rack, fill without overloading and without overlapping the dishes.

Always wipe the dishes before placing in the dishwasher; do not put dishes with dry or solid
residues in the washer.

Place the empty dishes in the rack facing downwards.

Place plates and the like in the sloping rack, with the inner surface facing upwards.

Place the cutlery in the cutlery basket, handle end down.

Do not place silver and stainless steel cutlery in the same cutlery basket as this will turn the silver
brown and may corrode the steel.

Wash the dishes immediately after use, in order to prevent any residue from hardening and sticking
on them.

Use only solid, dishwasher-proof dishes.

Select the appropriate washing cycle for the dishes using the buttons STATUS SELECTION (2)
and PROGRAMME SELECTION (3); these buttons are used in combination to select the desired
cycle, as shown in Fig.2.

To start the programme, press the START button (4). The WASHING LED (5) will start flashing and
the DISPLAY will show the washing temperature. Subsequently the RINSE LED (6) will start
flashing and the DISPLAY will show the rinse temperature.
(Fig.1 ).

At the end of the cycle, the WASHING (5) and RINSE (6) LEDs will flash simultaneously for a few
seconds.

For rapid drying, remove the rack from the machine as soon as the cycle finishes.

To stop a wash cycle early, press down and hold the START (4) button for a few seconds.
INSTRUCTION MANUAL FOR DISHWASHERS

Chap 4 USING THE MACHINE

5 WASHING LED
6 RINSE LED
7 INFORMATION DISPLAY
8 REGENERATION LED
4.2

Switching the dishwasher on

4.4

Cycle selection and start-up

4.4.1 Under-counter dishwashers

UK

4.1 Key and symbols

4.3

Filling the rack

Page 7 of 14