Before Use - Black & Decker BXCSH1200E Mode D'emploi

ENGLISH (Original instructions)
♦ Misuse or failure to follow the instructions may be
dangerous and void the warranty and the manufacturer's
liability.
DESCRIPTION
A Front panel
B Control panel
C Air outlet
D On/off switch
E Rear panel
F Feet
1 Display (by default shows the ambient temperature)
2 Night function control light
3 Button (-)
4 Night function
5 Day function control light
6 Heating element on
7 Button (+)
8 Day function
9 Mode / 'Open Window' function
INSTALLATION
♦ Be sure to remove all packaging material from inside the
appliance.
♦ Make sure that the appliance is level with respect to the
floor.
♦ Install the appliance away from flammable material such
as textiles, cardboard, paper, etc.
♦ Install the appliance at least 50 cm away from flammable
materials, such as curtains, furniture ...
♦ Ensure that neither the air access nor exit become either
totally or partially covered by drapery, clothing, etc., as
this increases the risk of fire.
♦ If mounted on a bathroom wall, place it so that the
socket outlet, power cable, switches or other controls
cannot be reached by anyone in the bathtub, shower or
at the washbasin.
Assembling the wall bracket:
♦ The appliance has a wall bracket used to support the
product .
♦ Fix the wall bracket as you think appropriate, using wall
plugs, screws...
♦ Taking the safety distances mentioned above into
account, place the wall brackets in the required position
and mark the drilling points on the wall . (Fig.1).
6
♦ Drill on the marks and insert the wall plugs. (Fig.1).
♦ Position the brackets, lining up its holes with those in the
wall plugs, and screw it on. (Fig.1).
♦ Make sure that the brackets are firmly fixed; it should be
able to support at least twice the weight of the appliance.
♦ Fit the appliance onto the wall support.
Fitting the base feet
♦ The appliance has base feet (F) on which the product
can be supported.
♦ To fit the base feet, place the appliance face down.
♦ Place the base feet on the body of the appliance.
♦ Use the screws to attach feet to the body (Supplied with
the appliance)
♦ Stand the appliance up again and check that the base
feet work properly.
INSTRUCTIONS FOR USE

Before use:

♦ Remove the appliance's protective film.
♦ Make sure that all the product's packaging has been
removed.
♦ Certain parts of the appliance have been lightly greased,
consequently, the appliance may give off a light smoke
the first time it is used. After a short time, this smoke will
disappear.
♦ To eliminate the smell given off by the appliance when
used for the first time, it is recommended to have it on at
full power for 2 hours in a well-ventilated room.
♦ Prepare the appliance according to the function you wish
to use.
Once you have finished using the appli-
ance:
♦ Turn the appliance off, using the on/off switch.
♦ Unplug the appliance from the mains.
♦ Clean the appliance
Safety thermal protector:
♦ The appliance has a safety device, which protects the
appliance from overheating.
♦ When the appliance switches itself on and off repeatedly,
for reasons other than the thermostat control, check to
ensure that there are no obstacles that impede correct
air entry or expulsion.
♦ If the appliance turns itself off and does not switch itself
on again, unplug it from the mains supply and wait ap-
proximately 15 minutes before reconnecting it. If it fails to