Glass Removal; Safety Precautions - Faber FEG4916F Manuel D'instructions

Glass Removal

WARNING: Turn off the fireplace and allow time for the unit to cool before attempting to remove the glass .
CAUTION: The ceramic glass is very fragile and should be handled with care .
WARNING: Do not operate the appliance with glass removed, cracked or broken . Replacement of the panel(s)
should be done by a licensed or qualified service person .
! NOTE: Two suction cups are needed to remove the glass . These are supplied with the fireplace .
1 . Loosen the coupling nuts on the bottom front
glass bracket using a small wrench or socket
set . Do not completely remove .
*Product may not be exactly as shown
3 . Carefully taking a sharp blade and cut silicone sealant front edges on exposed glass edges .
4 . Attach glass suction cups to the glass . Remove the last coupling nut and hold glass with suction cups and
remove top bracket completely from trim . Using two suction cups, gently raise glass and remove bottom of
glass from bottom bracket . Slowly swing glass out from bottom and remove glass .
5 . Place glass panel in a safe place, being careful not to chip glass edges that are very fragile .
If side glass needs to be removed, repeat steps 1 to 5 for the side glass as well .
! NOTE: When removing the side glass, the back brackets will also need to be loosened with a small wrench or
socket set before the glass can be removed .
CAUTION: When putting the glass back, DO NOT overtighten the bolts or glass may break .

SAFETY PRECAUTIONS

2 . Remove coupling nuts from top front glass
bracket using a small wrench or socket set .
Remove all coupling nuts leaving the middle
one until last .
58